Now knit 24 rounds as follows: Needles 1 and 2 in pattern I and follow chart for needles 3 and 4. Needle 3: k2, follow chart up to its centre. Needle 4: follow chart from middle to edge, k2. Material:  75g of 6-ply sock yarn, 120 seed beads (4mm with silver in the middle – or whatever you like) Set of 5 DPNs size 3.0mm or 3.5mm (if you are a tight knitter) Pattern:  Pattern I – p2, k2 Pattern II – follow chart BO – exchange every 2^nd and 3^rd stitch of pattern I – you can now knit k1, p1. Stitches of pattern II are knit k1, p1 as well. After 2 rounds in k1, p1 use Italian BO.  CO 60st. Rounds 1-10: p2, k2 around. Round 11:  Needle 1 - p2, k2, p2, k2, p2, k2, p2, k1 Needle 2 – k1, p2, k2, p2, k2, p2, k2, p2 Needle 3 - k2, p2, k10, p1 Needle 4 - p1, k10, p2, k2 Start Thumb Gusset: You need to add 16 stitches. In every third round you M1 after the 14^th st on Needle 4 and after the first stitch on needle 1. Knit those extra stitches in pattern I, keeping it correct. After you have finished making new stitches, knit 2 more rounds – following pattern I and pattern II. Then put the last 9 stitches on needle 4 and the first 9 stitches on needle 1 onto a stitchholder/scrap yarn. You now have to CO 2 more stitches (backward loop method) at the end of needle 4. Go on knitting in rounds as before, palm in pattern I and back of hand in pattern II until you have finished 60 rounds in pattern (6 pattern repeats). Now BO as mentioned above (or use your usual BO). Make thumb: Put the 18st from holders onto three needles, pick up 2 more stitches from the two CO stitches. Knit 10 rounds following pattern I, BO. Make second writwarmer – don’t forget to put thumb onto other side.